Feeler: Rear upper control arms.

Charlvdw · Post by **Charlvdw** » Wed Jul 01, 2009 9:52 am

Ill post pics tomorow morning. Just want to see the interest in order to know how many adjusters i need to have machined which will affect the cost. They will enable you to adjust your camber more than the std arms.
Should cost between R800 and R1000 per set. Ive imported some which cost me R1300 landed with a favorable Rand.

phoenix s14 · Post by **phoenix s14** » Wed Jul 01, 2009 10:27 am

Depending on the joints though. I know of quite a few people cursing them rose joints...
Will you be looking at doing them for S14 too? and how jou going to be sure that they are strong enough?

Charlvdw · Post by **Charlvdw** » Wed Jul 01, 2009 11:23 am

phoenix s14 wrote:Depending on the joints though. I know of quite a few people cursing them rose joints...
Will you be looking at doing them for S14 too? and how jou going to be sure that they are strong enough?

Strong enough would be an interesting subject.

Ill see where i can improve the once ive bought. Rose joints arnt my favorate either but can you imagine selling something like this in the us and they go defect the next week? They come with 14mm rose joints which is fairly ridged ,but if you were to hit a curd side ways i believe they might not survive along with your mags, bearings, sideshafts and alot more stuff. But if they brake in order to save the other stuff it would be alot cheaper then replacing your complete susspention on the one side.

Sorry to much coffee

300sx · Post by **300sx** » Wed Jul 01, 2009 3:05 pm

you think poly bushes are hard? try rose-joints..