Hey guys... as those who read my article section knows... I need to rebuild my motor
fun times ahead!! haha
So my Q is...
What parts will I need? what will I need to to get checked etc?
Taking into account the motor was still running fine. no smoke really and a bit of a bearing eating... hehe
oh want to redo the head too
partslist:
Rings
Bearings (bigends and mains)
Remove and Clean oilfeeds for cams
Last edited by Riekert on Tue May 25, 2010 5:13 pm, edited 1 time in total.
Enzio wrote:Who needs ligths? When you're going sideways forward facing lights don't do anything but confuse squirrels and sheep next to the road...
One thing you must do for sure is take the heads off the oil feeders to the cams clean them out and weld the end close again, cause all that shit in the oil gets stuck in that little holes in the pipe, trust me i made that mistake the first time and it was costly. there is a company in jhb that i send my stuff to that will about do everything for you, head, block, balance and what ever you want, call its Fullrace engineering 011 433 4506
