cooler pipes

AR 200SX · Post by **AR 200SX** » Mon May 19, 2008 7:26 pm

what would be the correct size cooler pipes to and from the cooler on a sr20det with 600mm x 300mm x 76mm cooler?

AR 200SX · Post by **AR 200SX** » Sun May 25, 2008 9:31 am

nobody wana share??

veecee · Post by **veecee** » Sun May 25, 2008 9:36 am

dont think anybody is sure!!!

i've seen various sized setups, and i'm also not sure of the science behind it!!!

but most intercoolers are 76mm inlet and outlet right??? and most of the piping i've seen is smaller than that.

what about the same (or similar) size to your TB???

Doctor G · Post by **Doctor G** » Sun May 25, 2008 8:15 pm

My FMIC is that same size and the cooler pipes are about 63mm. Haven't measured them so I'm guessing 63mm but the silicone adaptors at the tank ends def reduce a fair bit before joining to the pipes.

CA18 though.

AR 200SX · Post by **AR 200SX** » Mon May 26, 2008 6:00 pm

ian from rezlo says 64mm in and out.i have 64mm out and 76mm in at the moment.

Doctor G · Post by **Doctor G** » Mon May 26, 2008 6:05 pm

When u say in/out do you mean the cooler or the motor or what?

mine would be 63-ish from turbo to cooler. 76mm inlet on cooler. 76mm outlet on cooler. then 63-ish again from cooler to TB.

AR 200SX · Post by **AR 200SX** » Mon May 26, 2008 6:19 pm

the in/out on the cooler is 76mm. i am talking about the pipes. one from turbo to cooler,and from cooler to tb.

veecee · Post by **veecee** » Mon May 26, 2008 6:32 pm

AR 200SX wrote:ian from rezlo says 64mm in and out.i

seems to be sound advice man.

i know lots of people running that size without problems.

*Nissan 200SX Club - South Africa

cooler pipes

cooler pipes

cooler

cooler

cooler

Re: cooler