Want something to buy? This is for you
Moderators: P3g4sus , Daniel , rat , Draco , Riekert
SXing
Slipping Clutch
Posts: 19 Joined: Sun Sep 18, 2011 3:55 pm
Car: S13
Post
by SXing » Sun Sep 18, 2011 5:52 pm
Im looking for a side gauge pod where two gauges can be installed. Yeah autostyle has it but im not sure if they fit etc. Dont want it to look cheap.
Iv got a AEM air/fuel ratio gauge like this:
I want to get a boost gauge that looks goos and similar. Any suggestions? Oh and i don't want to dig too deep
Should look something like this after its done:
Shot!
k.y.l.e.
Over Boosting
Posts: 1122 Joined: Fri Jan 29, 2010 9:43 am
Car: S13
Engine: RB
Real Name: kyle
Location: Cape Town
Post
by k.y.l.e. » Sun Sep 18, 2011 6:56 pm
Where you located i can get a 3pod side gauge holder if you intrested
My LuGnuts have more torque than your honda.
EX=toyota corolla 160i 93'model
Current car=s13 200sx with s14 motor sr20det v.v.t .
SXing
Slipping Clutch
Posts: 19 Joined: Sun Sep 18, 2011 3:55 pm
Car: S13
Post
by SXing » Sun Sep 18, 2011 7:40 pm
Im not Cape Town...not sure if id want a 3pod though...
NIZAN-R
Over Boosting
Posts: 1201 Joined: Tue Jan 08, 2008 10:11 pm
Car: S13
Real Name: Renier
Location: PTA & Perth
Post
by NIZAN-R » Mon Sep 19, 2011 4:19 am
auto gauge ones are good takes some triming to fit flush
but looks decent
She is not the
CA that could be
She is the
CA that IS
(
O = O )/
RS13 \(
O = O )
"if you only need one jack to raise your car, then your car isn't low enough"
"EVERYDAY I'M FLUTTERING!"
Skylinefreak
0.5 Bar Boost
Posts: 520 Joined: Sat Oct 24, 2009 1:52 pm
Car: Other
Engine: RB
Post
by Skylinefreak » Mon Sep 19, 2011 6:06 am
Acoustic Audio can make you a custom one - their work is very neat. They're in Boksburg about 1km from Turbo Toys.
SXing
Slipping Clutch
Posts: 19 Joined: Sun Sep 18, 2011 3:55 pm
Car: S13
Post
by SXing » Mon Sep 19, 2011 12:26 pm
Cape Town guys
BigKriss
SX Forumholic
Posts: 2332 Joined: Fri Jan 21, 2011 7:40 pm
Car: S14
Engine: RB
Post
by BigKriss » Thu Sep 22, 2011 3:58 pm