Installing A FMIC - Advice Req.

[Fastlane]

Hi guys,

Thinking of installing a FMIC.

Question is : how do you route the IC Piping without removing the battery tray?

Anyone have pics of their install?

[aep886]

the best solution is you still have to remove the tray... and get a smaller battery...

[Fastlane]

Was actually hoping not to remove tray.

I wonder if it can be done without removing the Battery and tray?!?

[rat]

Was actually hoping not to remove tray.

I wonder if it can be done without removing the Battery and tray?!?

cut a hole in the tray?

[aep886]

cut a hole in the tray?

+1

[Ero_sennin]

this is where mine goes through on both sides

[Jacquesopper]

<a href="http://s1203.photobucket.com/albums/bb3 ... tpipes.jpg" target="_blank"><img src="http://i1203.photobucket.com/albums/bb3 ... tpipes.jpg" border="0" alt="Photobucket"></a>

<a href="http://s1203.photobucket.com/albums/bb3 ... tpipes.jpg" target="_blank"><img src="http://i1203.photobucket.com/albums/bb3 ... tpipes.jpg" border="0" alt="Photobucket"></a>

I took mine on the side of the battery , and there was no need to cut anything .

[Fastlane]

Thanks, guys, but I still have the original clutch fan on the motor.

Any other possible solutions.

[djtreble]

If you need the fan there is no other solution bud.
Vut through the tray and eith run a thin battery or put it in the back.

[Ero_sennin]

To be honest I would keep the Stock fan... daai ding waai woes