Page 1 of 1
loom plugs
Posted: Tue Oct 19, 2010 8:48 pm
by DriftZ
Howzit
Where can i get new loom plugs? ...i need the plug that fits onto a standard nissan water temp sensor ( sr20 )
Posted: Thu Oct 21, 2010 12:46 pm
by Guy
There is a company here in Richards Bay called Proloom, they build wiring looms and may have the correct plug.
I got them to match up some pins for my ecu plug.
Posted: Thu Oct 21, 2010 4:04 pm
by DriftZ
hey Guy.. long time.. hows the rebuild going?
.. i just need that one plug.. how can i get hold of these peeps?
Posted: Fri Oct 22, 2010 9:26 am
by Guy
Pro Loom
Tel : 035 751 1343
Fax : 035 751 1348
Cell : 084 588 7049
Email :
gerritbez@telkomsa.net
Postal Address : P.O. Box 8789
Richards Bay
3900
Physical Address : 50 Ceramic Curve
Alton North
Richards Bay
3900
Posted: Fri Oct 22, 2010 1:17 pm
by DriftZ
ta
Posted: Mon Nov 15, 2010 9:33 pm
by POWDER
Wouldn't nissan have, should be the same as on the sabre sti... I'm actually also looking for a few spare actually, well all the plugs, for temp, tps and coils.
Posted: Tue Nov 16, 2010 7:50 am
by DriftZ
POWDER wrote:Wouldn't nissan have, should be the same as on the sabre sti... I'm actually also looking for a few spare actually, well all the plugs, for temp, tps and coils.
before i phoned @Guy's loom place i when past a scrapyard.. first car as i stepped into the lot was a sabre.. had everything i needed.. for R20
Posted: Mon Nov 22, 2010 8:54 pm
by POWDER
Shweet, good to hear you got it all, especially since plugs normally cost about R20 each...
Posted: Tue Nov 23, 2010 1:53 pm
by Riekert
DriftZ wrote:POWDER wrote:Wouldn't nissan have, should be the same as on the sabre sti... I'm actually also looking for a few spare actually, well all the plugs, for temp, tps and coils.
before i phoned @Guy's loom place i when past a scrapyard.. first car as i stepped into the lot was a sabre.. had everything i needed.. for R20
next time get me some too please
still want to tuck the wiring