Nissan 200SX Club - South Africa

Hey guys... as those who read my article section knows... I need to rebuild my motor

fun times ahead!! haha

So my Q is...

What parts will I need? what will I need to to get checked etc?
Taking into account the motor was still running fine. no smoke really and a bit of a bearing eating... hehe

oh want to redo the head too

partslist:

Rings
Bearings (bigends and mains)
Remove and Clean oilfeeds for cams

One thing you must do for sure is take the heads off the oil feeders to the cams clean them out and weld the end close again, cause all that shit in the oil gets stuck in that little holes in the pipe, trust me i made that mistake the first time and it was costly. there is a company in jhb that i send my stuff to that will about do everything for you, head, block, balance and what ever you want, call its Fullrace engineering 011 433 4506

yeah was told about the oil feeds on the cams...

Fullrace you say. nice!

only issue is that I'm in CT... so it gonna cost me a crapload to courier too and from....

Ian sends his stuff up from pe to full race, its not that much if you get the right courier. these guys do a real good job

Cool Thanx!