Nissan 200SX Club - South Africa

Any one?

how much?

Still deciding. Will be in the region of R1000 and a old set.

That's a bit pricey isn't it?

Stephen Swanepoel wrote:That's a bit of a ripp isn't it?

The adjuster is a bit complex to make seeing that you are working with left and right hand thread at the same time and the fact that i only had 10 made and not a hundred isn't helping in the cost cutting department. Rose joint aren't cheap either.
Maybe you should get a few prices and see what you can do it for.
I would call it expensive not a "Ripp".
But like i said I'm still doing the math so no final price yet.

i think it looks cool...well done charl.

Your reasons seem fair.

No arguments there.

@ Zack : Thank's man.
@Stephen: I agree its pricey but its an expensive part to make unfortunately.

I payed R1300 for the once i imported, so I'm trying to built it for less than that at least.