Page 1 of 1
need this part, can anybody help me out?
Posted: Mon Nov 02, 2009 8:14 pm
by norb
Hey whats up everyone,
so my car is a bit screwed and i need the gaskets for the exhaust manifold, does anybody have any that i could buy?
its for the CA18 motor, thanks. take it easy
Posted: Mon Nov 02, 2009 8:23 pm
by cursed_s13
Do what I did. Get a sheet of Grapite/steel gasket from Gasket Manufactures and cut ur own gasket
It cost me cheaper and then you got some leftover for more gaskets
Posted: Mon Nov 02, 2009 9:03 pm
by rat
R40 each at nissan
R20 each at autozone
Posted: Mon Nov 02, 2009 9:17 pm
by WooHaa
just check the quality of the non-nissan gaskets.
Might be a good reason they are cheaper.
Aside from Graphite, I know copper or stainless steel is good replacement.
P.S.
Don't forget the locking plates for the bolts.
Posted: Mon Nov 02, 2009 9:56 pm
by rat
WooHaa wrote:just check the quality of the non-nissan gaskets.
Might be a good reason they are cheaper.
Aside from Graphite, I know copper or stainless steel is good replacement.
P.S.
Don't forget the locking plates for the bolts.
The Autozone ones were crap when i got them.
Locking plates very important
Rezlo can get the cometic gaskets for about R350 a set.
Posted: Tue Nov 03, 2009 7:12 am
by poizen
i have copper lazer cut gaskets for the ca18det R250 a set