Page 1 of 1
do you know how
Posted: Fri Jul 31, 2009 11:54 am
by poizen
hey guys i need help i gather this is a boost solonied but can comebody show how theirs connects to as i wanna see if mine is done correctly and what does it do
i need to know where a-
b-
c-
connect to
and can some one also send me just the motor stip and assemble part of the service manual
Posted: Fri Jul 31, 2009 12:00 pm
by rat
A - Intake pipe
B - FPR
C - back of intake mani
iirc
Posted: Fri Jul 31, 2009 12:09 pm
by poizen
ok well me c goes to intake and a or b go to fpr and intmani
Posted: Fri Jul 31, 2009 12:45 pm
by poizen
ok well i went to do it the way the rat said i round the inletman went to fpr and fpr went to inlet man and the intake pipe wasnt even in
will this cause any trouble the way it was set up for me
and what exactly does it do
Posted: Fri Jul 31, 2009 1:12 pm
by rat
boost cut. but you got a dicktator now? it shouldn't do anything
Re: do you know how
Posted: Fri Jul 31, 2009 2:11 pm
by Riekert
poizen wrote:hey guys i need help i gather this is a boost solonied....
my advice... take it out and see how far you can throw it....
Posted: Mon Aug 03, 2009 8:22 am
by poizen
i dont have dicktator yet so i need it but how can i throw it away
if i take it out will it stop boost cut and is i take it out will i not loose fuel pressure so then ill need to get a aftermarket fpr
Posted: Mon Aug 03, 2009 9:34 am
by Riekert
poizen wrote:i dont have dicktator yet so i need it but how can i throw it away
if i take it out will it stop boost cut and is i take it out will i not loose fuel pressure so then ill need to get a aftermarket fpr
not sure if it will eliminate boost cut... but I removed mine. rerouted a few of the vacuum pipes etc... but no issues so far. still using the same FPR too...