Nissan 200SX Club - South Africa

How do I do this, where can I get it done..

Mr Veec had a set at a good price, where did you get it made up.

Do you think this is a good Idea to go 100 x 5?????

hey drillergy...

i changed mine from 4x114.3 to 4x100 using 25mm steel plates, with recessed holes for the original bolts to go into. the spigot thingy was perfectly matched to the mags that i was putting on.'

i had it made up at an engineers place - it cost about 350-00 per wheel.

never had a days issue with them.

but the best bet is to contact craig at tires on 14th. he offers them at around about the same price, might be slightly cheaper. i never had mine painted or anything, but craig has them electroplated to prevent rust. they do a great job on their spacers.

look them up in the phonebook or lookout for their regular advert in SnS!

Thanks boet,just wata needed!!!