cooler pipes
Posted: Mon May 19, 2008 7:26 pm
what would be the correct size cooler pipes to and from the cooler on a sr20det with 600mm x 300mm x 76mm cooler?
Nissan 200SX Club - South Africa
Forum for owners of the Nissan 200SX in South Africa
https://forum.sxoc.co.za/
cooler pipes
Page 1 of 1
cooler
Posted: Sun May 25, 2008 9:31 am
nobody wana share??
Posted: Sun May 25, 2008 9:36 am
dont think anybody is sure!!!
i've seen various sized setups, and i'm also not sure of the science behind it!!!
but most intercoolers are 76mm inlet and outlet right??? and most of the piping i've seen is smaller than that.
what about the same (or similar) size to your TB???
i've seen various sized setups, and i'm also not sure of the science behind it!!!
but most intercoolers are 76mm inlet and outlet right??? and most of the piping i've seen is smaller than that.
what about the same (or similar) size to your TB???
Posted: Sun May 25, 2008 8:15 pm
My FMIC is that same size and the cooler pipes are about 63mm. Haven't measured them so I'm guessing 63mm but the silicone adaptors at the tank ends def reduce a fair bit before joining to the pipes.
CA18 though.
CA18 though.
cooler
Posted: Mon May 26, 2008 6:00 pm
ian from rezlo says 64mm in and out.i have 64mm out and 76mm in at the moment.
Posted: Mon May 26, 2008 6:05 pm
When u say in/out do you mean the cooler or the motor or what?
mine would be 63-ish from turbo to cooler. 76mm inlet on cooler. 76mm outlet on cooler. then 63-ish again from cooler to TB.
mine would be 63-ish from turbo to cooler. 76mm inlet on cooler. 76mm outlet on cooler. then 63-ish again from cooler to TB.
cooler
Posted: Mon May 26, 2008 6:19 pm
the in/out on the cooler is 76mm. i am talking about the pipes. one from turbo to cooler,and from cooler to tb.
Re: cooler
Posted: Mon May 26, 2008 6:32 pm
seems to be sound advice man.AR 200SX wrote:ian from rezlo says 64mm in and out.i
i know lots of people running that size without problems.