Page 1 of 1
for ERO_SENNIN: SR20 favour to ask!
Posted: Mon Apr 21, 2008 7:33 pm
by veecee
hey ERO,
please can you do me a big flavour!
i need to measure a few things for my SR20 swap into the s13 chassis.
i need to know:
1. the distance from the center of the motor to the center of the throttlebody.
2. and i need to know the angle of the throttle body, although i'm quite its 45 degrees. but i just need confirmation.
3. the distance between the front of the tappet cover to the front valance (the bit that the top of the radiator mounts to.
thanks lots.
VC
Posted: Tue Apr 22, 2008 5:20 pm
by Ero_sennin
huh
Posted: Tue Apr 22, 2008 5:24 pm
by Slide 'em Wide
@ ero dont you know the angle between the rotator split and rocacum converter.
Posted: Tue Apr 22, 2008 5:27 pm
by Ero_sennin
Slide 'em Wide wrote:@ ero dont you know the angle between the rotator split and rocacum converter.
The what
Posted: Tue Apr 22, 2008 5:58 pm
by Slide 'em Wide
I measured mine with an ice cream stick and a pair of scissors,
You find all of the instructions imprinted under the driver seat.
Posted: Tue Apr 22, 2008 6:36 pm
by Ero_sennin
veecee where do you live?
Posted: Tue Apr 22, 2008 10:58 pm
by veecee
in jhb, near cresta center!
beyers naude offramp on the n1!
Posted: Tue Apr 22, 2008 11:47 pm
by Ero_sennin
ok never mind, Ill rather measure than drive all the way to you
Just explain 1 and 3 to me exactly from where to where, I done want to give you wrong info then you come try to hunt me down and drive over my dog or something
cause I am guessing you want to fabricate something.
Posted: Tue Apr 22, 2008 11:57 pm
by veecee
1. center of the tappet cover (valve cover - yours is big and red!!! hard to miss) to the center of the throttle body.
3. distance between the engine and the radiator, plus the thickness of the radiator!
that help?
Posted: Wed Apr 23, 2008 12:27 pm
by Ero_sennin
ok that should do, Now just to find out what I did with my measuring tape.
Posted: Thu Apr 24, 2008 11:27 pm
by Ero_sennin
Ok found my measuring tape, will do this for you and post
Sorry's I took so long, works a biyatch
Posted: Sat Apr 26, 2008 11:25 am
by Ero_sennin
1. 26.5 cm
2. 45 degrees
3. 30 cm
Hope this helps.
PS. how is the project coming along?
Posted: Mon Apr 28, 2008 4:26 pm
by veecee
thanks lots ero...
its coming along, but oh so damn slowly at this stage.
there is still lots i need to buy and no money to do it with...
i'm thinking of making a deal with the devil...
