200SX S13 Bolt-In rollcages
Posted: Thu Oct 09, 2014 3:34 pm
Hey guys.
Our new JIG is done, we are now ready to start selling our revised design (now sunroof friendly).
We are doing a introduction price of R5500 (normal price will be R6000). These are dash dodger cages, however if you would like a straight bar (dash will need to be cut then), just let me know.
Cage specs:
- Main hoop 45 OD & 3mm thick CDS
- Rest 38 OD & 3mm thick CDS
- 120mm x 120mm 3mm thick base plates
- 10mm bolts with minimum of ISO 8.8 rating
- 26.5 kg in total
These were cleared by MSA when Supradrift was held in Cape Town, our sponsored SX competed in the event with our cage installed.
Door bars can be done at a additional charge, but I do not promote this if car is used on the street.
These are perfect for track days or those that use their road cars for a bit of drifting. Takes that extra twist out of the chassis.
Only 2 spanners needed and 15-20 minutes to install.
Contact for orders:
sales@c-teq.co.za
Our new JIG is done, we are now ready to start selling our revised design (now sunroof friendly).
We are doing a introduction price of R5500 (normal price will be R6000). These are dash dodger cages, however if you would like a straight bar (dash will need to be cut then), just let me know.
Cage specs:
- Main hoop 45 OD & 3mm thick CDS
- Rest 38 OD & 3mm thick CDS
- 120mm x 120mm 3mm thick base plates
- 10mm bolts with minimum of ISO 8.8 rating
- 26.5 kg in total
These were cleared by MSA when Supradrift was held in Cape Town, our sponsored SX competed in the event with our cage installed.
Door bars can be done at a additional charge, but I do not promote this if car is used on the street.
These are perfect for track days or those that use their road cars for a bit of drifting. Takes that extra twist out of the chassis.
Only 2 spanners needed and 15-20 minutes to install.
Contact for orders:
sales@c-teq.co.za