Nissan 200SX Club - South Africa

Posted: **Tue Sep 08, 2009 11:10 am**

angaaz, but still cheap cos its already got 2 x 12 inch fans installed on a 50mm

Posted: **Wed Sep 09, 2009 10:40 am**

ReeceZ wrote:angaaz, but still cheap cos its already got 2 x 12 inch fans installed on a 50mm

maybe

but good news CA sold so money to do clutch and zorst

Posted: **Wed Sep 09, 2009 11:30 am**

Are you also doing the full oil drive snout ?

Posted: **Wed Sep 09, 2009 12:29 pm**

Pinkfluffybunnys wrote:Are you also doing the full oil drive snout ?

will have to speak to the boss about that one

Posted: **Thu Sep 10, 2009 11:08 pm**

Pinkfluffybunnys wrote:Are you also doing the full oil drive snout ?

a what now?

Posted: **Thu Sep 10, 2009 11:49 pm**

Riekert wrote:
Pinkfluffybunnys wrote:Are you also doing the full oil drive snout ?
a what now?

the oil pump drive snout thing doesnt go very far in or something like that, so when you start pushing big numbers it can or will start giving problems

Pinkfluffybunnys wrote:For the RB guys.

You need money to play

Posted by rezlo
--------------------

First off, no matter the pump, make sure you have the full pump drive, most RB's besides late model RB26's have a very short contact area, this would need to be machined off and replaced with a full length unit.

Stock oil pump +/- R4000 - Not bad, doesnt fail often, can support good power, just dont bang it on the limiter.
Nissan N1 pump +/- R4800 - Total rubbish... the 2004 and older units were not as bad
Greddy +/- R9500 - Good, dont break to often but are known to have broken
HKS & Jun +/- R12 000 - Very good, very rare to hear of faliures unless its due to substantial abuse
Tomei +/- R15 000 - The best direct fit pump available, requires massive oil mods to stop over oiling

There are a few drop in gear sets available into stock housings, for the money you might as well get a greddy or HKS.

Me personaly, I would not go external pump, if your going to do the mission of mounting pumps, brackets, belts etc just go propper dry sump, will cost you similar to slightly more than a Tomei.

Remember, like an ECU is the brain of your car, the oil pump is the heart, if it fails you can spend massive money rebuilding, if not picked up right away it could cost you the whole motor.

http://shop.rezlo.com/forums/viewtopic.php?f=2&t=712

Posted: **Fri Sep 11, 2009 9:54 am**

It doesn’t take big numbers to make it fail..

They fail very often in close to stock forum from the research, I have done, Rev's seem to be the issue

I stand to be corrected but the problem is the snout is too small for the oil drive causing it to slowly eat into the drive resulting in gear failure and then engine failure.

The RB series motors had a few flaws, Stock from the factory the snout issues was fixed by Nissan in late model motors.

Not causing trouble ,Just asking out of interest

Also lookup the oiling issues the RB experiences

Posted: **Fri Sep 11, 2009 10:03 am**

Pinkfluffybunnys wrote: Not causing trouble ,Just asking out of interest

Also lookup the oiling issues the RB experiences

i am thankful for every bit of info

will do some reading into it

Posted: **Fri Sep 11, 2009 10:16 am**

To be honest, I want a RB25. I mean who doesnt ...

But you might need to fix these few flaws to keep you inversment going for years to come

Posted: **Fri Sep 11, 2009 5:03 pm**

INVESTMENT.......................

sorry pink,, but thats a killer

ive lost so much money on cars its not funny

i spent close onto R130k now and i probally can only sell for 80k

my suggestion is to think long and hard about doing conversions,
do it because you love it and you gona keep it and most of all, do it properly first time,,,, if you plan porperly you wont have to spend money twice on the same things

would i spend all that money again ...No

Posted: **Mon Sep 14, 2009 11:57 am**

I will be keeping my car for some time.

So i got the radiator and intake from turbo toys, gary or his dad should be collecting it today sometime.

Planned for this week:

Engine out for finial touches
Fix sump - got a ding in it
Painting of tappet covers - going for a gold like my mags. garys idea i think it going to look great
Cam Belt
Clutch - getting RB30 and making the pressure plate a double diaphram
Radiator in
Intake manifold

think that is about it for now

Posted: **Mon Sep 14, 2009 1:17 pm**

INVESTMENT.......................

sorry pink,, but thats a killer

ive lost so much money on cars its not funny

i spent close onto R130k now and i probally can only sell for 80k

my suggestion is to think long and hard about doing conversions,
do it because you love it and you gona keep it and most of all, do it properly first time,,,, if you plan porperly you wont have to spend money twice on the same things

would i spend all that money again ...No

LOL, True....

I should have worded it better

Posted: **Mon Sep 14, 2009 5:00 pm**

yeah, i love this part too..

do it because you love it and you gona keep it

then you realize there is no way in hell you are ever gonna recover what you spent.. never a truer word spoken on this forum

Posted: **Mon Sep 14, 2009 5:44 pm**

ive really had to hold myself back these past months, im itching for a boost controller...

Rat are you gona use ????

Posted: **Mon Sep 14, 2009 7:04 pm**

RBSX wrote: ive really had to hold myself back these past months, im itching for a boost controller...

Rat are you gona use ????

dont know yet, will see how the budget goes before buying the extras.

still got a manual one

Nissan 200SX Club - South Africa

Project - S13 Awesomeness