Nissan 200SX Club - South Africa

Daniel wrote:Need videos!

just waiting on my new spacers before i can start shredding tires but there will defiantly be videos in the near future

So now with the car been registered and legal on the road though id go celebrate so took the car to the rock to play abit. Its alot harder than it looks but heres a vid of my best attempt. i only had 5 runs at it then i burst a water line and car overheated lucky i saw it happening and was able to get off the track before anything got damaged

http://www.youtube.com/watch?v=5SgG5bOH ... e=youtu.be

Ok so after having a issue with a water pipe i decided to replace the water lines much to much disgust this is what I found....





So I made up a few new lines

looks like drifting!

how did you get back home?

pipe only leaked when that car was hot so i crawled home lol

So car made it to drag wars unfortunately the exhaust leak seemed to be getting worse so the car was only able to achieve 0.8bar boost but I still made do with what I had. Every run down the strip I was reducing my time nicely till they pulled me off the line for a oil leak, which I was pissed off about but quickly changed that attitude when I inspected this apparent oil leak, turns out the engine mount had broken and punchers a hole into my oil filter I had virtually no oil in my car and would have completely buggered up everything if they had let me run so unfortunately the car had to be brought home on a tailor but motor seemed fine will have to replace the filter and oil just to double check but now that its standing again I've decided to do a few upgrades and fix small issues that were long over due.

Ok so now that the car is standing its time for more upgrades lol ive made a list of all the issues i wanted to fix so the list is as follows

1. Full poly bush kit.
2. shime the diff to lock at around 60% load.
3. subframe c collars.
4. rebuild exhaust.
5. new exhaust mani gasket.
6. weld the cracks in the exhaust mani.
7. new heat wrap.
8. msd coil packs.
9. remove dash to fix anoying rattle.
10. find and fix rear rattle.
11. Rewire Spitronics for sequential fueling.
12. Engine flush new oil and filter.
13. reinforce engine mounts.
14. Big brake upgrade front and rear.
15. Big radiator
16. retune on higher boost!!

poly suspension and subframe collars = More rattles

haha that is true, must hear all the new rattles i got with my poly engine mounts

Ok so it starts....

Test fit the new Radiator




Pulled the exhaust, I'm going to remove that center box.



Pulled the intake off and found a leak.




While the intake is off I though I would give everything a good clean up!




And finally I picked up my new bigger brakes for the front and rear.

Cute Jason!!

If you take that centre box out it is going to be loud as fuck.
Ask me how I know.....

Lol its not my daily so loud is good. I assume u only did 1 box?

Is my car loud Jason?

Your car sounds nice