Nissan 200SX Club - South Africa

Ero_sennin wrote:Doesn't powder coating go through a very hot oven, at least my stuff I have sent does and takes kak long to cool down?

dont have a clue dude the previous owner did it

It's not powdercoated. It would have melted into a ball in the oven.

It would have been rattle canned - you can get a very good finish if you prep and spray it correctly.

possible the guy i bought it from powder coated a few things cuz he owns a powder coating shop. but ja come to think about it its impossible to powder coat something that doesnt conduct and wont melt lol

Lamin-X

looks fresh ! See you been attacking that orange peel hard style - liking this colour

after 3 polishes my hands are broken

OK Mr. Curry Powder ready to powdercoat tings for u

Sent from some crappy hand held device.

dude is she alive yet or what!!!!!!!!!!!!!

jap bled the brakes and clutch taking her on saturday to get exhaust done! but still cant get the rev counter to work

Its 1 wire to ur dash
Have u found the blue wire to your counTer

from what i can see its a yellow and red wire for the tacho and blue and black for temp sensor

Ok well just check. I left a piece of the original wire from the sx harness on. Just hunt for thoes and check in your workshop book for them..
Ya blue is water temp for the gauge.. Its been some time so can't remember the exact 1

So sx went on a trip to get he down pipe made up. Finally got to drive the car properly for the first time in a year and a half. car pulls very strong still on low boost but feels great. Had a couple of teething issues but thanks goodness that motor was built right(thanks Adrian) otherwise the might have been sad news today. After fiddling around with my grounding putting new plugs and sorting a water line out the car is pulling strong again

Well worth the effort man! Car is looking awesome

You still running at .8? Enjoy her man.. I want a spin dude!!