Nissan 200SX Club - South Africa

Very nice @ gary would love to see her go after the build

Intake manifold assembled



Pic of the port matched runners, before and after.

Awesome job Gary, enjoying the attention to detail.

mario_200sx wrote:Awesome job Gary, enjoying the attention to detail.

+1!

Just had these made...

good job dude love how clean your work is!!!!

Nice, looks neat. I still have my Gizzmo one in the cupboard, ready to install it when the motor comes out again.

Enzio wrote:Nice, looks neat. I still have my Gizzmo one in the cupboard, ready to install it when the motor comes out again.

so i take it you not selling anymore?

Sorry for the off topic, Gary.

SonOfAnarchy ZA wrote: so i take it you not selling anymore?

The car is actually still for sale, and I will repost it for sale in a little under a month if the car I want is still for sale. Basically the car will be for sale until the car I want to buy is sold - after that I will keep it until I find something else worthwhile to replace it with.

Just got back from getting engine bay resprayed...

Looks awesome Gary, very neat!

Sent from my Galaxy Nexus using Tapatalk

nice and neat! why such a fat gasket?

SonOfAnarchy ZA wrote:nice and neat! why such a fat gasket?

The gasket is made from Phenolic, it will act as a heat barrier and prevent heat from soaking into intake manifold and in turn meant to keep air cooler.

oh ok kwl

Anyone know where I can get these, they not listed with agents?