CA18DET Forged rebuild
Moderators: P3g4sus, Daniel, rat, Draco, Riekert
- mario_200sx
- 200SX Maniac
- Posts: 2507
- Joined: Fri Dec 14, 2007 9:16 am
- Car: S13
- Location: Cape Town
Re: CA18DET Forged rebuild
Start will no boost and slowly build from, it's now at 0.55.
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"
Re: CA18DET Forged rebuild
You need the high rpm to increase the wear on the rings, also running back against compression will help set the rings in the grooves. You must go to redline in order to wear the honing down, if not you can create a ridge.
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"
Re: CA18DET Forged rebuild
Just did leakdown test, results as follows after only 200km:
Cylinder 1 - 10%
Cylinder 2 - 9%
Cylinder 3 - 12%
Cylinder 4 - 11%
These results prove break in procedure worked...
Cylinder 1 - 10%
Cylinder 2 - 9%
Cylinder 3 - 12%
Cylinder 4 - 11%
These results prove break in procedure worked...
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"
Re: CA18DET Forged rebuild
Meth tank in, pump mounted.
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"
-
- Newbie
- Posts: 1
- Joined: Mon Sep 30, 2013 4:38 pm
- Car: S13
- Real Name: Stan
- Location: Helsinki, Finland
Re: CA18DET Forged rebuild
so neat and clean
Re: CA18DET Forged rebuild
So I ordered an eccentric throttle wheel from GKTech in Aus, was delivered in 6 days of placing order on the cheapest shipping service, brilliant.
Problem is it does not fit. The slot in the center is 90 degrees out so the cable does not fit. So I drop them a mail and after a few emails back and forth their attitude seemed to have changed and I was told the throttle body is incorrect and the wheel is correct. No where on there site does it say that the wheel would only fit certain throttle bodies...
Anyway I would not purchase anything from them again of any decent value in case my car is wrong for the part...
Here a few pics...
Problem is it does not fit. The slot in the center is 90 degrees out so the cable does not fit. So I drop them a mail and after a few emails back and forth their attitude seemed to have changed and I was told the throttle body is incorrect and the wheel is correct. No where on there site does it say that the wheel would only fit certain throttle bodies...
Anyway I would not purchase anything from them again of any decent value in case my car is wrong for the part...
Here a few pics...
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"
- DriftZ
- 200SX Maniac
- Posts: 2611
- Joined: Mon May 05, 2008 7:48 pm
- Car: S15
- Engine: SR
- Location: Durban
Re: CA18DET Forged rebuild
dont say i didnt warn you ...lol
Re: CA18DET Forged rebuild
Put it in milling machine and machine slot correct, will check tonight if it fits.
DriftZ: "I swear if a CA18 beats my SR im getting a RB!"