*Nissan 200SX Club - South Africa

SonOfAnarchy ZA wrote:pics or it didn't happen

Yeah Yeah... I know... excuse excuse excuse.... I will go get some

NEW MOTOR INSTALLED!

Over the Christmas break we pushed hard and got the new (as in refurbed RB26) into the car. We ran a very simple map to get it running.
Good News:-
Motor runs a peach
Everything is operating as expected
The tune has NO top end[/list]

Bad News:-
There is NO top end - needs dyne ...

PM sent

What's the mileage on these?


Sent from my iPhone using Tapatalk

Awesome... Great to see done more R32's coming in!


Sent from my iPhone using Tapatalk

Drillergy wrote:Its now one of the best looking R32s

Thanks... It's getting there...

Sent from my HTC One_M8 using Tapatalk

updates?
to be honest... bogger all.... I am waiting on a larger throttle body for the R33 and as soon as thats installed and the R33 is finally completed with its MOTEC tuned and gearbox replaced (OS Giken OS88) then I will get the R32 on the ramp for the engine swap... The post office strike is ...

PM sent... might be a good backup plan for my BC ER's
Later
Nick

Slowly looking for a R34... But looking for a v-spec in blue that has not been molested... Tough find...

Sent from my D6503 using Tapatalk

We have been finishing the R33 for the last two weeks. The Motec is now installed and it's been on two dyno sessions to clean up the tuning...
On the R32 the rear glass goes in and the bonnet go on next week.
We have prepped the replacement motor with replacement maintenence parts (oil pump, water ...

I will take engine and Haltech... Also looking for driver side windows switches
Thanks
Nick


Sent from my iPad using Tapatalk HD

Having rebuilt a number of these for a variety of reasons my primary advise would be to do a complete engine refresh, as apposed to just replacing old/damaged bits. I would advocate a complete stripdown and rebuild and if you are not going for big power then stock internals (excluding oil pump ...

SonOfAnarchy ZA wrote:looking good dude hope that intercooler outlet was covered up while they were sanding body filler dust gets everywhere

Yeah,
The entire intake was stripped off , flushed and returned. The dust just goes everywhere
Cheers
Nick

We have done a bunch more work on her and it is getting closer to being a complete body once again. I am being lazy and just dropping the body shop Facebook update below. If this is not appropriate could the mods let me know and i will delete and repost...
https://www.facebook.com/automc/posts ...

Started the hard work with reference to the body.
The body has been masked off and panels are being prepped. The rust has been cut out and the bonnet and boot stripped.
http://i655.photobucket.com/albums/uu280/scunick/R32%20GTR/DSC_0193.jpg
http://i655.photobucket.com/albums/uu280/scunick/R32 ...