Venom's 200sx
Moderators: P3g4sus, Daniel, rat, Draco, Riekert
- VeNoMiZeR
- 0.2 Bar Boost
- Posts: 204
- Joined: Sat Jul 25, 2009 10:46 am
- Car: Other
- Engine: SR
- Location: Bunbury Western Australia
Venom's 200sx
Hey there, Well I sold my Sentra neo vvl and bought this for a daily drive. Bought it in the freestate towed it back here in pta cause of the owner suspected a bearing knock. Busy fixing it up now, turns out the engine have piston slap causing the noise. I stip the engine complete and in the progress of rebuilding it. So far the gearbox is getting redone and recon the propshaft. Redid the whole interior fixing loose things and missing bolts ect.. Replaced this broken panels that i bought from Enzio this weekend, still alot of stuff to do but getting there slowly.
Okay its a Nissan 200sx s13 with Sr20det swop.
Got a t3/t4 turbo,63mm exhaust,dicktator management,intercooler,ali boost pipes,button clutch, afpr.ect..
Im' in need of a sunroof latch mine is broken, and a bumper stiffner please
After the sx is done back to the 200zr build progress
Okay its a Nissan 200sx s13 with Sr20det swop.
Got a t3/t4 turbo,63mm exhaust,dicktator management,intercooler,ali boost pipes,button clutch, afpr.ect..
Im' in need of a sunroof latch mine is broken, and a bumper stiffner please
After the sx is done back to the 200zr build progress
Current: 93 Pulsar SSS N14 Japspec (in Progress)
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
Here is the FS thread and the build thread, sadly the image hosting I was using seems to have dissapeared.
http://200sx.za.net/phpBB2/viewtopic.php?t=3284
http://200sx.za.net/phpBB2/viewtopic.php?t=2787
The car had knock when I bought it, we rebuilt the motor right, resleeved etc etc. at the time the engineer I used found the oil pump was in spec and didnt need to be replaced, but if its run bearings again (Though its been 2 - 3 years since I sold it) its definately time to look at a new pump or even an uprated pump.
The car had some good bits and some not so good bits, I was in the market for a drifter so didnt care much.
How much did you pick it up for if I may ask?
http://200sx.za.net/phpBB2/viewtopic.php?t=3284
http://200sx.za.net/phpBB2/viewtopic.php?t=2787
The car had knock when I bought it, we rebuilt the motor right, resleeved etc etc. at the time the engineer I used found the oil pump was in spec and didnt need to be replaced, but if its run bearings again (Though its been 2 - 3 years since I sold it) its definately time to look at a new pump or even an uprated pump.
The car had some good bits and some not so good bits, I was in the market for a drifter so didnt care much.
How much did you pick it up for if I may ask?
Captain Slow to the rescue!
- future sx owner
- 0.1 Bar Boost
- Posts: 184
- Joined: Tue Jun 01, 2010 6:37 pm
- Car: S13
- Location: centurion
- VeNoMiZeR
- 0.2 Bar Boost
- Posts: 204
- Joined: Sat Jul 25, 2009 10:46 am
- Car: Other
- Engine: SR
- Location: Bunbury Western Australia
Thats the car.. bought it from Elton in the freestate, honestly there where a whole lot of things wrong when i bought it. Since then i stripped the whole interior and redid the wirring and rerouted everything. Made a new harness for the management since the guy cable tied it under the steering colum. I bought pannels for the interior replacing every broken panel inside, Busy carbon wrapping the interior and installed some sound and a GReddy profec spec b boost controller. Found a vibration when towed the car back, turns out the bush on the extension housing of the g/box worn out end up damaging the propshaft. So recon the propshaft and g/box last week, this week busy with the engine prob going to resleeve it again since there is piston slap and put another set of pistons and rods in. The Mains is already at .25 oversize and big ends at .50 oversize. I want everything std again so rebuilding completely with cometic gaskets, original oil pump, acl bearings, balance, head flow, GTiR throttles, GReddy RAS, new boostpipes, old ones bended and leaking boost
Need to get a bumper stiffner to secure bumper since intercooler was fitted with no stiffner making the bumper sagg
next on my list Smash and grab tint, carbon bonnet, repainted bumper and bootlid.
@ Sokar i paid R37 000 for it
Need to get a bumper stiffner to secure bumper since intercooler was fitted with no stiffner making the bumper sagg
next on my list Smash and grab tint, carbon bonnet, repainted bumper and bootlid.
@ Sokar i paid R37 000 for it
Current: 93 Pulsar SSS N14 Japspec (in Progress)
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
Sheesh, well then its been "thouroughly enjoyed" since I sold it. I paid R50k for it with the bearing knock so I still think you have a bit of a bargain there.
I also has an issue with the speed sensor, it was out of an auto box apparently and read half of what it should (40 when you're doing 80 etc)
Even with all the niggles it still put 150kw on the rear wheels and the screamer pipe always made me smile
I also has an issue with the speed sensor, it was out of an auto box apparently and read half of what it should (40 when you're doing 80 etc)
Even with all the niggles it still put 150kw on the rear wheels and the screamer pipe always made me smile
Captain Slow to the rescue!
- VeNoMiZeR
- 0.2 Bar Boost
- Posts: 204
- Joined: Sat Jul 25, 2009 10:46 am
- Car: Other
- Engine: SR
- Location: Bunbury Western Australia
Did a small video of the sx but still alot of things to do before its ready
http://youtu.be/fIiQgaDGT1w
Getting there slowly
http://youtu.be/fIiQgaDGT1w
Getting there slowly
Current: 93 Pulsar SSS N14 Japspec (in Progress)
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
Ex:Nissan 300zx z32
Nissan S13 200sx SR20det
Nissan Sentra 200sti Neo Vvl
Nissan 200zr RB25det
Nissan 300zx z31 Vg30et
- POWDER
- Club Rep
- Posts: 1204
- Joined: Fri May 15, 2009 12:19 pm
- Car: S13
- Engine: SR
- Real Name: Mike
- Location: Johannesburg
Venom, some nice work going on here cuz, post some of ur processes so we can see some madness from your mind..... Lookin forward to seeing her go....
Carpe Diemotor - Sieze the motor today
- Nissan 200SX S13 92' SR20DET
http://200sx.za.net/phpBB3/garage_vehic ... cle&VID=14
- Nissan 200SX S13 92' SR20DET
http://200sx.za.net/phpBB3/garage_vehic ... cle&VID=14