Nissan 200SX Club - South Africa

Well done Eugene. Coming together!!

very nice power! at what boost level was that done on?

Grobblere wrote:,
Pic of clutch fitted to custom flywheel

How does the clutch feel ? Working well ?

Thanks guys!

The boost on the dyno graph shows 1.07 bar, but we are not done with the adjusting on the higher rev range. If i have my wastegate fixed we will continue tomorrow.

The clutch is great! Not too heavy on the foot, You just need to get used it it but id say its friendly enought for road use yet still holding on nicely...will see what it does once we reach 400whp and 450nm torque on the wheels. But im expecting it to hold on.

Welk done.!!! Nice power out of the CA!:shock: Impressed!

Thanks Drillergy

When we continue i hope we rev past 7500rpms atleast (want to set the limiter at 8200rpm's as the car peaks at +-7500rpm.

I see the guys put my cab on their site

http://www.facebook.com/photo.php?fbid= ... =1&theater

Hi Guys

Still busy with the tuning but here us up to the current progress.... (I must admit i feel sorry for all the guys who changed the ca out for a sr hehehe)

Dyno @ 1 bar Dyno @ 1.2 bar Dyno shows 1.3 but Johan says the dyno shows 0.1 over)...but we had a little issue so we stopped for now, some more hp to gain here. But i can see where my turbo's efficiency range is truly coming through.

very nice figures!

Lovely stuff there man. Very nice build!

So is the Dyno figures on the wheels or the fly?

Hi Charl...Thats wheel Hp. (No correction factors etc)

Very funny to see how the figures compare, my friends V6 twin turbo made 390whp on 0.7 boost on the same dyno.

I would ques his graph look completely deferent tho. What torque did he make at .7?

Hi Charl,

Here is a copy of his dyno run posted on their web site.

http://www.facebook.com/photo.php?fbid= ... =1&theater

His run was pump gas only.

He has loads more Torque and hp available at low refs, but my car is fine. It idles and drives like stock on the lower rpms....

Here is run of a rb25det (308whp @ 0.7 bar)
http://www.facebook.com/photo.php?fbid= ... =1&theater

Piet Jordaans' bakkie conversion
http://www.facebook.com/photo.php?fbid= ... =1&theater

And here is a run of another Ca18det monster... (592 hp and 666 torque)
http://www.facebook.com/photo.php?fbid= ... =1&theater

Nice Eugene, looking good, after the tuning you gotta start taking the tracks.

What's the lag like on your car Eugene?