Nissan 200SX Club - South Africa

O.o whaaaat? R40k? Daaaaaaaauuuummmmmnnnnnn... bye bye awesome interior hehe

Sent from my GT-I9100 using Tapatalk

Riekert wrote:O.o whaaaat? R40k? Daaaaaaaauuuummmmmnnnnnn... bye bye awesome interior hehe

Sent from my GT-I9100 using Tapatalk

We used 8sqm of alcantara which is running at R5,5k per square... Fucking ridiculous increase in price of it over the last three years... Interior took 240 man hours to assemble.... Just lots if cash... When it's finally finished it will be awesome!!!

Send from my Xperia Z1

wow. Can imagine man! can't wait to see it!

Sent from my GT-I9100 using Tapatalk

While we source all of the stuff for the engine rebuild we decided to start the external cosmetic work... lets just say that stripping was a very interesting exercise and a whole bunch of new issues popped up....

First thing that popped up was how badly the bumper support had been hack to fit the intercooler.

There is absolutely NO support across 2/3rds of the support. We will need to fabricate something to give it something to brace the central bumper to. The grill attachments have also been cut out....

Under the rear rocker panel covers we found our old friend tinworm...


One of my personal favourites... the "professionally fabricated" fender upper bumper mount...


Not to mention that none of the trim was removed the last time it was sprayed so we have the joy of stripping all this crap off before we can start laying clean paint...


Add to that the botch job done on Hicas elimination and general poor state of everything....

Oh well... onward and upward...

Later
Nick

The link to the post by my body shop
https://www.facebook.com/automc/posts/7 ... =notify_me

from what i hear alb is closing down can see why

Started the hard work with reference to the body.
The body has been masked off and panels are being prepped. The rust has been cut out and the bonnet and boot stripped.

RESPECT to you my dear sir!

You've been done in yet you continue to give this car the re-birth it deserves!

Keep up the good work and updates.

Awesomeness!!!

Sent from my GT-I9100 using Tapatalk

We have done a bunch more work on her and it is getting closer to being a complete body once again. I am being lazy and just dropping the body shop Facebook update below. If this is not appropriate could the mods let me know and i will delete and repost...
https://www.facebook.com/automc/posts/745050142218163

Cheers
Nick

looking good dude hope that intercooler outlet was covered up while they were sanding body filler dust gets everywhere

SonOfAnarchy ZA wrote:looking good dude hope that intercooler outlet was covered up while they were sanding body filler dust gets everywhere

Yeah,
The entire intake was stripped off , flushed and returned. The dust just goes everywhere
Cheers
Nick

Matt black paintjob.... Looking schweeet!

Nice work man! Lets hope she visits Durbs one day

Update?

We have been finishing the R33 for the last two weeks. The Motec is now installed and it's been on two dyno sessions to clean up the tuning...
On the R32 the rear glass goes in and the bonnet go on next week.
We have prepped the replacement motor with replacement maintenence parts (oil pump, water pump, cam belt etc) and will do the swap in the next few weeks. Once the "bad" motor is out we will start forging the bottom end and eventually drop it back into The R32.

I am however very excited to the R33 complete after the install of is OS88 gearbox and Motec ECU and electronic throttle...

I also made a "Little" purchase a short while back...

Sent from my D6503 using Tapatalk